Long Level Marina - Lake Clarke

Just a few of the services we provide:

Certified Mercury Marine and Mercruiser Service Center
Major and minor mechanical service on most brands of boats, motors and trailers
Drop or Pull Mooring
Fabrication Work, Stick & Tig Welding
Boat Detailing
Interior structure work
Minor gel coat
Battery Charging
Salvage and dive work for docks, moorings and boats
Service calls on water and land
Crane work on water and land
Holding tank pump out service
Port-a-potty clean station
Road legal boat hauling
Boat brokerage
Boat and trailer registrations
Propeller repair and selection

Labor Rate is between $25.00 and $85.00 per hour. The job determines the rate.

NOTE: We no longer work on Force or SportJet motors of any year. We no longer work on motors older than 1985.

Our January 2005 project was to completely rebuild our workboat. The workboat was used on Lake Clarke since 1990, dropping and pulling moorings, salvage work, service calls, towing, delivering travel trailers to the islands, etc. With all of the abuse over the years the recreational tubes that were under the deck had to be upgraded. New commercial grade 34 foot square type tubes with trapezoid bottoms that are 1/4" thick chambered tubes with 1/2" thick skid plates. The skid plates allow us to now pull right up on ramps without worry. The workboat is powered with twin Mercury 135 OptiMax outboards. We'll be able to maneuver into the tightest spots now. Additionally the motors are now environmentally friendly and provide an even more dependable service boat for the lake.

Click on an image below for larger version

Dale Service Manager Mercury Marine Master Technician Click here to view plaque	Jason	Ben	Jason
Smoke	Tractor Bob	Brandon	Mike H.
Glenn	Mike McLain	Ricky